Jetway NF631 3.5" SBC Motherboard |
Processor | Intel® Pentium N4200 Processor Quad Core 1.10 GHz - 2.50 GHz, 6W TDP Intel® Celeron N3350 Processor Dual Core 1.10 GHz - 2.40 GHz, 6W TDP * Ships with black finned heatsink for bench testing |
Memory | 1 x 204-pin DDR3L-1866 SO-DIMM up to 8GB (1.35V required) |
Graphics | Intel HD Graphics 505, 200MHz - 750MHz (N4200) Intel HD Graphics 500, 200MHz - 650MHz (N3350) |
Audio | Realtek ALC662 HD Audio Realtek ALC888 HD Audio (Manufacturered after March 2021) |
LAN | 2 x Intel i211AT PCI-E Gigabit LAN |
Storage | 1 x SATA3 6Gb/s Connector 1 x M.2 SATA M-key 2242 length only |
Super IO | FINTEK F81866 |
TPM | Intel fTPM 2.0 (PTT) Trusted Computing Firmware |
Back Panel Connectors |
2 RJ45 LAN (10/100/1000)
4 USB 3.0
1 3.5mm Audio Jack (Line-out & MIC)
1 RJ45 Type Serial Port (RS232)
2 Display Port (4096 x 2160 @ 60Hz)
1 +12V 2.5mm Diameter DC Power Jack
|
Onboard I/O Connectors |
1 SATA3 6Gb/s Connector
1 M.2 SATA 2242 only
1 Mini PCI Express Slot (Full-size)
5 Serial Headers (4 * RS232, 1 * RS232/422/485)
1 USB Pin Headers for up to 2 additional USB 2.0 Ports
1 40-pin eDP (4096 * 2304 @ 60Hz)
1 SIM Card Socket
1 Micro SD Card Slot
1 8 bit GPIO Header
1 AT/ATX Mode Jumper
1 6-pin PS/2 Mouse/Keyboard Header
1 9-pin Front Audio Header
1 5-pin SMBUS Header
1 4-pin Fan Header
1 4-pin Floppy Power Output (Male)
1 2-pin +12V Alternate Power Connector
|
Power Supply for NF631 |
External Power Supply – the board can be powered with a +12V external power supply though a DC connector on the back panel. The rear +12V DC jack accepts plugs with an inner diameter (ID) of 2.5 mm and an outer diameter (OD) of 5.5 mm, where the inner contact is +12V and the shell is GND.
Internal Power Supply – the board can alternatively be powered via the internal +12V 2-pin power connector, where pin 1 is +12V and pin 2 is GND. The internal 2-pin power connector accepts a JST VHR-2N or TE 1-1123722-2 plug from the power supply.
Caution: There is no isolation circuitry between the external +12V DC jack and the internal 2-pin power connector. It is the system integrator's responsibility to ensure no more than one power supply unit is or can be attached to the board at any time and to ensure the external +12V DC jack is covered if the internal 2-pin power connector is to be used.
|
Market Segments Supported |
√ Digital Signage
√ Retail (POS/Kiosk/ATM)
|