| Model Name | NF832 |
| Part Number | JNF832-3455 |
| Form Factor | 3.5" SBC (148 x 102mm) |
| Processor | Intel® Celeron J3455 Processor Quad Core 1.50 GHz - 2.30 GHz, 10W TDP
* Ships with silver flat heatsink for bench testing |
| Memory | 1 x 204-pin DDR3L-1866 SO-DIMM up to 8GB (1.35V required) |
| Graphics | Intel HD Graphics 500, 250MHz - 750MHz (J3455) |
| Audio | Realtek ALC662 HD Audio
Realtek ALC888S/897 HD Audio (Manufacturered after May 2021) |
| LAN | 1 x Realtek RTL8111H PCI-E Gigabit LAN |
| Storage | 1 x SATA3 6Gb/s Connector
1 x M.2 SATA M-key 2242/2280 length |
| Super IO | FINTEK F81962D |
| TPM | Intel fTPM 2.0 (PTT) Trusted Computing Firmware
OEM Option: Onboard TPM v1.2 or v2.0 |
| Back Panel Connectors |
1 3.5mm Audio Jack (Line-out)
1 RJ45 LAN (10/100/1000)
1 Micro SIM Slot
2 HDMI 1.4b (3840 * 2160 @ 30Hz)
4 USB 3.0
1 +12V 2.5mm Diameter DC Power Jack
|
| Onboard I/O Connectors |
1 SATA3 6Gb/s Connector
1 M.2 SATA 2242/2280 M Key
1 M.2 PCI-E 2230 E Key
1 Mini PCI Express Slot (Full-size)
1 Serial Headers (1 * RS232)
1 USB Pin Headers for up to 2 additional USB 2.0 Ports
1 40-pin eDP (3840 * 2160 @ 60Hz)
1 Micro SIM Slot
1 8 bit GPIO Header
1 AT/ATX Mode Jumper
1 9-pin Front Audio Header
1 5-pin SMBUS Header
1 4-pin Fan Header
1 4-pin SATA Power Output (Male)
1 2-pin +12V Alternate DC-in (Mating plug: JST VHR-2N or TE 1-1123722-2)
|
| Power Supply for NF832 |
External Power Supply – the board can be powered with a +12V external power supply though a DC connector on the back panel. The rear +12V DC jack accepts plugs with an inner diameter (ID) of 2.5 mm and an outer diameter (OD) of 5.5 mm, where the inner contact is +12V and the shell is GND.
Internal Power Supply – the board can alternatively be powered via the internal +12V 2-pin power connector, where pin 1 is +12V and pin 2 is GND. The internal 2-pin power connector accepts a JST VHR-2N or TE 1-1123722-2 plug from the power supply.
Caution: There is no isolation circuitry between the external +12V DC jack and the internal 2-pin power connector. It is the system integrator's responsibility to ensure no more than one power supply unit is or can be attached to the board at any time and to ensure the external +12V DC jack is covered if the internal 2-pin power connector is to be used.
|
| Market Segments Supported |
√ Digital Signage
√ Retail (POS/Kiosk/ATM)
|
| Environment |
Operating Temperature : 0 ~ 60°C
Storage Temperature : -20 ~ 85°C
|
