| Jetway NF9C Mini-ITX Motherboard |
| Processor | 3rd Generation Intel® Atom Dual Core N2600 (1.6GHz@3.5W)
3rd Generation Intel® Atom Dual Core N2800 (1.86GHz@6.5W) |
| Chipset | Intel NM10 |
| Memory | 1 x DDR3-800 SO-DIMM slot up to 2 GB (N2600 version)
2 x DDR3-800/1066 SO-DIMM slot up to 4 GB (N2800 version) |
| Graphics | PowerVR SGX 545 (GMA 3600@400MHz) Integrated Graphics (N2600 version)
PowerVR SGX 545 (GMA 3650@640MHz) Integrated Graphics (N2800 version) |
| Audio | Realtek ALC662 5.1 Channel Audio |
| LAN | 1 x Realtek RTL8111EVL PCI-E Gigabit Ethernet |
| Storage | 2 x SATA3 6Gb/s ports
1 x SATA2 3Gb/s Port
1 x CFast Socket |
| Super IO | FINTEK F71869A |
| Back Panel Connectors |
1 12V DC Jack
1 HDMI (1920 x 1200 @ 60 MHz)
1 COM (RS232)
3 USB 2.0
1 RJ45 LAN (10/100/1000)
1 3.5mm Audio with S/PDIF out
|
| Onboard I/O Connectors |
1 PCI Slot
1 mini PCI-E Slot
2 Serial header (RS232)
1 Serial header (RS232/RS422/485)
2 SATA3 6Gb/s Connectors
1 SATA2 3Gb/s Connectors
2 USB Pin Headers for up to 4 additional USB 2.0 Ports
1 Parallel header
1 32-pin 24-bit dual channel LVDS1 header/inverter (CHRONTEL CH7511B chipset up to 1920 x 1200)
1 32-pin 18-bit single channel LVDS2 header/inverter (PowerVR SGX 545 chipset)
1 GPIO header
1 VGA header
1 9-pin Audio header
1 Keyboard/Mouse header
1 4-pin 12V ATX Power Connector for alternate internal power supply
1 4-pin Power out header
1 Front Panel header
3 Fan header
|
| Power Supply for NF9C |
External Power Supply – the board can be powered with a 12 V external power supply though a DC connector on the back panel. The rear 12 VDC jack accepts plugs with an inner diameter (ID) of 2.5 mm and an outer diameter (OD) of 5.5 mm, where the inner contact is 12 V and the shell is GND.
Internal Power Supply – the board can, alternatively, be powered by an internal ATX12V 2 x 2 power connector.
Based on power consumption test results, the recommended power rating is 60 W (12 V/5 A).
Caution: There is no isolation circuitry between the external 12 VDC jack and the internal 2 x 2 power connector. It is the system integrator's responsibility to ensure no more than one power supply unit is or can be attached to the board at any time and to ensure the external 12 VDC jack is covered if the internal 2 x 2 power connector is to be used.
|
| Market Segments Supported |
√ Digital Security & Surveillance
√ Digital Signage
√ Gaming
√ Industrial Automation/Control
√ Medical
√ Retail (POS/Kiosk/ATM)
√ Networking/Storage Server/Mail Server/Print Server
√ Thin Client
√ HTPC
|
